Version: Rainmeter 4.5.18.3727 (64-bit)
I use win11 x64 fully updated (including drivers).
On last version, Rainmeter stall after this step (proved more than once, always stall/crash):
Start your PC with NO Internet connection, keed the LAN cable connected though.
I use Proxmox (VM) and have pfSense on it (on a dedicated server [Xeon]), so it takes like 90 secs (or less) to be fully up (online).
My PC has a 14700K with m2 on it so it starts (fully boot) under win11 in seconds.
IF I start my PC (win11) BEFORE Proxmox is fully ready, Rainmeter tries to update the new IP by looking/searching for it. Once the Internet comes UP, Rainmeter just STALL.
I need to force end task it, and run rainmeter again, in order to get it working.
Please, check it out.
Thanks.
I use win11 x64 fully updated (including drivers).
On last version, Rainmeter stall after this step (proved more than once, always stall/crash):
Start your PC with NO Internet connection, keed the LAN cable connected though.
I use Proxmox (VM) and have pfSense on it (on a dedicated server [Xeon]), so it takes like 90 secs (or less) to be fully up (online).
My PC has a 14700K with m2 on it so it starts (fully boot) under win11 in seconds.
IF I start my PC (win11) BEFORE Proxmox is fully ready, Rainmeter tries to update the new IP by looking/searching for it. Once the Internet comes UP, Rainmeter just STALL.
I need to force end task it, and run rainmeter again, in order to get it working.
Please, check it out.
Thanks.
Statistics: Posted by Gradius — Yesterday, 7:52 pm — Replies 1 — Views 54